Sunday, June 16, 2019

Accident Victim Interview Report Essay Example | Topics and Well Written Essays - 500 words

Accident Victim Interview Report - Essay ExampleThe victim was engrossed in his job and since he was w spikeing ear buds to protect him with too much noise he didnt notice the chaos. He was unfortunately caught by the fireball after the explosion and sustained singe injuries. The quick action of his fellow co-workers and immediate first aid given to him saved his life.The Chemical Safety Board investigated the cause of slash and reported that a contractor had accidently switched a carbon steel pipe elbow with a low alloy steel pipe elbow during the maintainance work. This caused rupture in the pipe leading to leading to a failure mode called High- Temperature Hydrogen Attack (HTHA) causing fireball. The CBS found that it was not solely the mistake of the contractor, the company had not apprised that the elbows were different and the maiintainance contractor had not used any method like tagging to re-install the elbows in their position. The victim was without delay rushed to the nearby infirmary where he was immediately diagnosed and admitted for treatment.Doctors reported 20 percent first degree minor skin burns on covering his upper part of the body. He stayed in the hospital for about a week and missed work for another week before recovery. Some burn marks he still sustains on his body, tho he is completely fit for work and thanks God for giving him a second life. The company took responsibility to bear the cost of his treatment and the grok union also demanded descent compensation for him till he recovered and joined work again. His company has witnessed two more accident cases prior to this unmatched and they were fatal accidents leading to severe loss of capital and labour. This accident was followed by OSHA visit to issue safety guidelines and check the safety standards in the refinery.Following this accident the CBS recommended that industry should have its own committee to monitor the safety standards, hazard identification and

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.